Signal Turn On / Off; Keyboard Sound Turn On / Off - Hermle Z 287 A Operating Manual

PRODUCT DESCRIPTION
ATTENTION:
- The normal program mode can be changed back again by switching off the centrifuge,
for a short period!
All changed settings must be confirmed by the key "store" or "start" (9). A confirmation
-
screen will appear with the word, "store", in the display "rpm/rcf" (A-1) - Only then the
pre-selections are valid!
1.8.2

Signal Turn On / Off

Proceed as illustrated, under point 1.8.1, to enter this program mode, press the key; "accel/decel"
(5). In the display, "accel/decel" (A-2) flashes the word, "service". Select the letter, "L" with the
control field (1). As a result, appearing in the display "rpm/rcf" (4), are the words, "On Sound". By
pressing the key, "rpm/rcf" (4), the word "On" flashes, and the sound can be switched off with the
control field (1), (see Figure 3).
After the settings have been stored by user, the normal program mode can be changed back again
by switching off the centrifuge, for a short period.
Figure 3

1.8.3 Keyboard Sound Turn On / Off

Proceed as illustrated, under point 1.8.2, to enter this program mode, press the key, "accel/decel"
(5). In the display, "accel/decel" (A-2) flashes the word, "service". Select the letter "b" with the control
field (1). As a result, appearing in the display, "rpm/rcf" (A-1), the word "ON/BEEP". After pressing
the key, "rpm/rcf" (4), turn the keyboard sound (On) or (Off), with the rotorary field (1), (see Figure
4).
After the settings have been stored by user, the normal program mode can be changed back again
by switching off the centrifuge, for a short period.
10
Z287A_V1.19_
eng
2
3
© Hermle Labortechnik GmbH