Signal Turn On / Off (Optional); Volume Pre-Selection Of Sound Signal (Optional) - Hermle Z 216 MK Operating Manual

1.8.4 Signal Turn On / Off (optional)

Proceed as illustrated, under point 1.8.1, to enter this program mode, press the key; "accel/decel"
(5). In the display, "accel/decel" (A-2) flashes the word, "service". Select the letter, "L" with the
adjustable knob (1). As a result, appearing in the display "rpm/rcf" (4), are the words, "On Sound".
By pressing the key, "rpm/rcf" (4), the word "On" flashes, and the sound can be switched off with the
adjustable knob (1), (see Figure 6).
After the settings have been stored by user (see 1.8.2), the normal program mode can be changed
back again by switching off the centrifuge, for a short period.
Firgure 6

1.8.5 Volume Pre-Selection of Sound Signal (optional)

Proceed as illustrated, under point 1.8.1, to enter this program mode, press the key "accel/decel" (5).
In the display, "accel/decel" (A-2), flashes the word, "service". Select the letter, "U" with the
adjustable knob (1). As a result, appearing in the display, "rpm/rcf" (A-1), are the words, "Vol=0-
9/Sound". By pressing the key, "rpm/rcf" (4), the desired volume can be adjusted between 0 (low)
and 9 (loud), with the adjustable knob (1), (see Figure 7).
After the settings have been stored by user (see 1.8.2), the normal program mode can be changed
back again by switching off the centrifuge, for a short period.
Figure 7
© Hermle Labortechnik GmbH Z216MK_V1.19_eng
PRODUCT DESCRIPTION
9
8
1
7
13