Access To The Mode: "Standard Settings; Signal Turn On / Off - Hermle Z 207 M User Manual

Table of Contents

1.8.2 Access to the Mode: "Standard settings"

While starting this model, the following basic settings can be performed:

The following operating data can be retrieved in this menu:

Open the centrifuge lid and shut off the main switch. Now switch on again the main switch. For

approximately 3 seconds the software version and the model type will be shown in the display (see

Figure 1). Press during this time the keys "time" (6) and "lid/stop" (10) simultaneously. As a result, a

display test is administered for approx. 3 seconds. All possible indications will appear at the same

time (see Figure 3).

Figure 3

ATTENTION:

The normal program mode can be changed back again by switching off the centrifuge,

for a short period!

All changed settings must be confirmed by the key "store" or "start" (9). A confirmation

screen will appear with the word, "store", in the display "rpm/rcf" (A-1) - Only then the

pre-selections are valid!

1.8.3

Proceed as illustrated, under point 1.8.2, to enter this program mode, press the key; "accel/decel"

(5). In the display, "accel/decel" (A-2) flashes the word, "service". Select the letter, "L" with the

control field (1). As a result, appearing in the display "rpm/rcf" (4), are the words, "On Sound". By

Signal Turn On / Off

Keybord Sound On / Off

Sleep Mode On / Off

Number of Starts

Operating Hours of Centrifuge

Operating Hours of Motor

Software Version

Error List

Function of the Imbalance Switch

Operation of Keyboard

Hardware Version

Intermediate Circuit Voltage in Volt

Display Tests

Z207M_V1.21_eng

PRODUCT DESCRIPTION

Table of Contents