Table of Contents
Advertisement
SmartNode 5540E & 4140E Series User Manual
IP addresses and/or URL of SIP servers or Internet telephony services (if used)
•
•
Login and password for PPPoE Access
Login and Password for SIP based telephony services
•
IP addresses of central TFTP server used for configuration upload and download (optional)
•
Software tools
The simplest way configuring the SmartNode is through
Alternatively you may use the Web interface in combination with a Web wizard to get your unit up and run-
ning. For more details, see the
The Command Line Interface is also supported for configuration, and can be accessed through Telnet /SSH.
Also see the
Knowledgebase
Power source
Patton recommends that you include an uninterruptible power supply (UPS) in the installation to ensure that
VoIP service is not impaired if the power fails.
Installing the SmartNode device
SmartNode device installation consists of the following:
1. Placing the device at the desired installation location (see section
page 31)
2. Installing interface cables (see section
3. Connecting power (see section
When you finish installing the SmartNode device, go to Chapter 5,
Placing the SmartNode device
If you will be installing the SmartNode device in an equipment rack, see Appendix G,
Rack Ears"
on page 68.
If you will be installing the SmartNode device on a DIN rail, see Appendix H,
Mounting Clip"
on page 70.
Otherwise, place the SmartNode device on a desktop or similar sturdy, flat surface. Allow sufficient space at the
rear of the chassis for cable connections. Additionally, you should consider the need to access the unit for future
upgrades and maintenance.
To prevent overheating and damaging the unit, proper ventilation is required when
placing the device; leave at least 2 inches (5 cm) to the left, right, front, and rear of
the SmartNode device.
CAUTION
The device should be installed in a dry environment with sufficient space to allow air
circulation for cooling. Do not stack multiple SmartNode devices directly on top of
one another, and do not place items on top of the device. If you will be installing
equipment above the SmartNode device, leave at least 2 inches (5 cm) of clearance
between the devices.
Installing the SmartNode device
Wizard
Portal.
for config snippets when configuring your device through CLI.
"Connecting cables"
"Connecting the power supply"
Patton
Cloud.
"Placing the SmartNode device"
on page 32)
on page 34)
"Initial Configuration"
"Installing Optional DIN Rail
4 • SmartNode Installation
on
on page 37.
"Installing Optional
31
Advertisement
Table of Contents
