Table of Contents
Advertisement
SmartNode 5540E & 4140E Series User Manual
3. Insert the positive lead into the opening on the terminal block labeled + and the negative lead into the
opening on the terminal block labeled -.
4. Tighten the screws on the block to secure the wires.
5. Apply power to the power source.
The SmartNode device does not have a power switch; it powers on when the
Note
power source is activated.
6. Verify that the green POWER LED is lit (see
phase and blinks slowly during the boot process. It stay lit constantly when the system is up and running.
Congratulations, you have finished installing the SmartNode device! Now go to Chapter 5,
tion"
on page 37.
Installing the SmartNode device
figure 11
on page 35). It blinks quickly during bootloader
4 • SmartNode Installation
"Initial Configura-
36
Advertisement
Table of Contents
