Adjusting The Mower; Dismounting The Mower Deck - Kubota ZD1600 Series Operator's Manual

ADJUSTING THE MOWER

10. Install the universal joint.
Push the universal joint onto the PTO shaft until the
coupler locks.
IMPORTANT :
• Tug the universal joint backward and
forward to make sure it is locked securely.
(1) Universal joint
(2) Coupler
11. After mounting the mower, check the mower level. If
necessary, adjust the mower level and anti-scalp
rollers.
ADJUSTING THE MOWER
(See OPERATING THE MOWER on page 62 and
ADJUSTMENT on page 111.)
DISMOUNTING THE MOWER
DECK
1. Before dismounting the mower deck, rise the lift
links to the full up position.
(See STARTING THE MACHINE on page 53.)
2. Place 50 mm (2 in.) wood blocks under each side of
the mower deck.
3. Adjust the cutting height control dial to the 1 in.
position.
4. Lower the mower deck to the lowest position.
5. Detach the universal joint.
Pull back the coupler of the universal joint.
ZD1611LF,ZD1611RLF,ZD1611RL
(1) Universal joint
(2) Coupler
6. Detach the lift links from the mower deck with
attaching hardware.
(1) Lift link
(2) Clevis pin, plain washer, snap pin
7. Tilt up the machine with the maintenance lift
system.
(See TILTING UP THE MACHINE on page 71.)
MOWER MOUNTING
(A) "PULL"
29