Table of Contents
Advertisement
OPERATING A NEW MACHINE
OPERATING THE MACHINE
OPERATING A NEW MACHINE
DANGER
To avoid serious injury or death:
• Do not operate the mower without the discharge
deflector in the down position.
WARNING
To avoid serious injury or death:
• The machine relies upon the engine driven
transmission for speed, direction, and motion
control. If the engine is not running, the
machine cannot be driven or controlled.
If the engine stops when operating on a slope,
apply the parking brake immediately to prevent
a machine runaway.
• Do not allow anyone other than the driver to
ride on the machine.
• Do not drive the machine close to the edges of
ditches or banks which may collapse under the
weight of the machine, especially when the
ground is loose or wet.
• When making a turn, reduce the travel speed
and operate the motion control levers carefully.
• To avoid tip-over accidents, operate across
slopes, not up and down. Avoid sudden starts
and stops on slopes. Slow down and use extra
caution when changing direction on a slope.
Park the machine on a firm and level surface.
• Watch where you are going at all times. Watch
for and avoid obstacles. Be alert at curbs, near
trees, and other obstructions and hidden
hazards.
• Do
not
mow
near
embankments. The mower could turn over if a
wheel is over the edge of a cliff or ditch, or if an
edge caves in.
• Do not drive the machine on streets or
highways. Watch for traffic when you cross
roads or operate near roads.
• Look to the rear before and when backing. Make
sure the area immediately behind you is clear of
obstructions or holes, and small children. Use
extra caution when the machine is equipped
with a grass catcher.
• Keep bystanders, especially children, and
animals away from the mowing area.
• Clear the work area of objects which might be
picked up and thrown by the blades.
ZD1611LF,ZD1611RLF,ZD1611RL
drop-offs,
ditches
or
• Do not direct the opening of the discharge
deflector at bystanders or animals. Discharged
objects may cause injury. Plan your mowing
carefully before starting operation.
• Disengage the PTO and sit on the operator's
seat before starting the engine.
How a new machine is operated and maintained will
determine the operating life of the machine.
A new machine just off the factory production line has
been tested, but the various parts are not accustomed
to each other, so care should be taken to operate the
machine for the first 50 hours at a slower speed and
avoid excessive work or operation until the various
parts become "broken-in". The manner in which the
machine is handled during the "breaking-in" period
greatly affects the life of your machine.
Therefore, to obtain the maximum performance and the
longest operating life of the machine, it is very
important to properly break-in your machine. In
handling a new machine, the following precautions
should be observed.
1. Changing lubricating oil for new
machine
The lubricating oil is especially important in the case of
a new machine. The various parts are not "broken-in"
and are not accustomed to each other. Small metal grit
may develop during the operation of the machine and
this may wear out or damage the parts. Therefore, care
should be taken to change the lubricating oil a little
earlier than it would ordinarily be required.
Details regarding normal service intervals can be found
in a different section.
(See SERVICE INTERVALS on page 84.)
2. Engine break-in
After the first 50 hours of operation, change the engine
oil and filter.
(See EVERY 200 HOURS on page 97.)
3. Machine break-in
After the first 400 hours of operation, change the
transmission oil.
(See EVERY 400 HOURS on page 98.)
After the first 50 hours of operation, change the oil filter.
(See EVERY 200 HOURS on page 97 and EVERY
400 HOURS on page 98.)
OPERATING THE MACHINE
51
Advertisement
Table of Contents
Troubleshooting
