DPF REGENERATION PROCESS
10. Press the parked regeneration switch
The switch lamp will stop flashing and remain "ON" constantly during the cycle.
11. The engine rpm will automatically rise, and the regeneration process will start.
NOTE :
• For a while after the start of regeneration, the engine runs at high speed for warming it up and
regeneration of electricity.
12. Both indicators
They turn "OFF" when the cycle is complete.
13. After the lamp turns "OFF", normal machine work may resume.
When driving in "Regeneration inhibit" mode, keep pressing the regeneration inhibit switch for 5 seconds to turn
on the switch lamp.
NOTE :
• During the regeneration cycle, do not touch the above levers and switches (in steps 2, 3, 4), nor change
the engine rpm other than for an emergency stop. Otherwise, the regeneration will be interrupted.
• Never leave the machine when the parked regeneration process is activated.
• If the parked regeneration cycle is interrupted, the engine rpm is fixed at the idling level for about 30
seconds. For this period, keep the hand accelerator lever at the idle position. Do not move it. It will
function again in 30 seconds.
ZD1611LF,ZD1611RLF,ZD1611RL
to start the regeneration cycle.
LCD monitor display
stay "ON" while regenerating the DPF.
LCD monitor display
OPERATING THE ENGINE
43