TIRES AND WHEELS
TIRES AND WHEELS
TIRES
WARNING
To avoid serious injury or death:
• Do not attempt to mount a tire. This should be
done by a qualified person with the proper
equipment.
• Always maintain the correct tire pressure.
Do not inflate tires above the recommended
pressure shown in the Operator's Manual.
• The inflation pressure in the front tires rises
quickly when using compressed air.
• Never operate the machine with a loose rim,
wheel, or axle.
• Whenever
bolts
retighten to the specified torque.
• Check all the bolts and nuts frequently and
keep them tightened.
1. Inflation pressure
Even though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course
of time. Therefore, check it everyday and inflate as
necessary.
Tire sizes
15 × 6.5 - 8, Smooth semi-
Front
pneumatic tire
26 × 12.0 - 16, 4PR turf
Rear
low profile tire
(1) Ground
68
and
nuts
are
loosened,
Recommended inflation
pressure
-
83 kPa
2
0.84 kgf/cm
12 psi
(A) "INSUFFICIENT"
(B) "NORMAL"
(C) "EXCESSIVE"
WHEELS
IMPORTANT :
• When refitting a wheel, tighten the wheel bolts
and nuts to the following torques then recheck
after traveling 200 m (200 yards), changing
directions several times.
Rear
⋅ m
(1) 108.5 to 130.2 N
⋅ ft
80 to 96 lbf
⋅ m
11.1 to 13.3 kgf
When using wheels with beveled or tapered holes, use
tapered wheel bolts and nuts.
1. Removing the front caster wheels
(1) Lock nut
(2) Wheel bolt
(3) Yoke
1. Park the machine on a firm and level surface.
2. Stop the engine and apply parking brake.
3. Lift the front of machine with a safe lifting device.
TIRES
ZD1611LF,ZD1611RLF,ZD1611RL