Lcd Monitor; Fuel Gauge; Coolant Temperature Gauge - Kubota ZD1600 Series Operator's Manual

LCD MONITOR

(3) Engine oil pressure warning indicator
If the oil pressure in the engine goes below the
prescribed level, the warning indicator in the Easy
™
Checker will come on.
If this should happen during operation, check the
level of engine oil.
(See Checking the engine oil level on page 78.)
(4) Master system warning indicator
If trouble should occur at the control parts, the
indicator flashes as a warning. If the trouble is not
corrected by restarting the machine, consult your
local Kubota Dealer.
(5) Air heater indicator
When using the heater, the air heater indicator
turns on.
(6) Water separator warning indicator
If water or impurities collect in the water separator,
the indicator on the Easy Checker
this should happen during operation, drain the
water from the water separator as soon as possible.
(See Checking water separator on page 79.)
(7) Emission warning indicator
If this indicator lights up, take steps to lower the
water temperature. This helps keep the emission
clean.
(8) Fuel level warning indicator
If the fuel in the tank goes below the prescribed
level, the warning indicator in the Easy Checker
will come on.
If this should happen during operation, refuel as
soon as possible.
(See Checking the amount of fuel and refueling on
page 78.)
IMPORTANT :
• When the fuel warning indicator lights up,
refuel the tank as soon as possible. If the
machine runs out of fuel and stalls, the
engine and its
damaged.
NOTE :
• For checking and servicing of your machine,
consult your local
instructions.
ZD1611LF,ZD1611RLF,ZD1611RL
™
will light up. If
™
components may be
Kubota Dealer for
LCD MONITOR
(1) LCD monitor

1. Fuel gauge

When the key switch is on, the fuel gauge indicates the
fuel level.
Be careful not to run the fuel tank completely empty.
Otherwise air may enter the fuel system.
Should this happen, the fuel system must be bled.
(See Bleeding fuel system on page 107.)
(1) Fuel gauge

2. Coolant temperature gauge

WARNING
To avoid serious injury or death:
• Do not remove radiator cap until coolant
temperature is well below its boiling point. Then
loosen the cap slightly to relieve any pressure
before removing the cap completely.
1. With the key switch "ON", this gauge indicates the
temperature of the coolant. [C] for "cold" and [H] for
"hot".
2. If the indicator reaches the [H] position, engine
coolant is overheated.
OPERATING THE ENGINE
(A) "EMPTY"
(B) "FULL"
47