FRONT AXLE
1. Open the front cover.
2. Remove the 2 L-pins from their original position.
(1) L-pin
(2) Snap pin
3. Insert L-pins into the holes on the front axle as
shown below.
(1) L-pin
4. Install the snap pins between the axle mount frame
and the front axle.
(1) L-pin
(2) Snap pin
ZD1611LF,ZD1611RLF,ZD1611RL
2. Oscillating the front axle
For oscillating the front axle, reverse the previous
procedures.
The oscillating front axle provides a smoother ride than
the rigid front axle and oscillates with the terrain.
PARKING THE MACHINE
WARNING
To avoid serious injury or death:
Before leaving the operator's position:
• Apply the parking brake.
• Lower all implements to the ground.
• Shut off the engine.
• Remove the key.
• Place
the
motion
"NEUTRAL LOCK" position.
To lock:
1. Depress the parking brake pedal firmly with your
right foot, and the parking brake lock pedal
simultaneously with your left foot.
2. Then release the parking brake pedal while holding
the parking brake lock pedal down.
To unlock:
Depress the parking brake pedal and release it slowly
with your right foot without pressing the parking brake
lock pedal.
If necessary to park on an incline, chock the wheels on
the downhill side to prevent accidental rolling of the
machine.
(1) Chock
NOTE :
• See Parking brake pedal on page 55.
ACCESSORY
1. 12 V electric power socket
You may use the 12 V electric power socket to connect
an auxiliary light or other devices.
OPERATING THE MACHINE
control
levers
in
the
59