1. Observe the safety and ESD precautions at the beginning of this book.
2. Turn off all peripheral devices connected to the server. Turn off the server.
3. Disconnect the power cord.
4. Remove the four screws (see letter "A").
5. Slide cover back and lift upward (see letter "B").
Installing the System Cover
1.
Place the top cover on system and slide towards the front of chassis until the recessed front
edge is fully engaged. (see letter "A").
2.
Install the three screws at the front and torque to 7-9in-lbs, then install the screw at the
back and torque to 7-9in-lbs. (see letter "B").
3.
®
Intel
Server System R2000BB Service Guide
6.
Figure 33. Removing the System Cover
Figure 34. Installing the System Cover
Hardware Installations and Upgrades
27