FL SWITCH 2000 / FL NAT 2000
44 / 226
PHOENIX CONTACT
4.2.3
Possible operating modes in Smart mode
The switch supports the selection of the following operating modes in Smart mode:
Table 4-1
Operating modes in Smart mode
Mode
Exit Smart mode without changes
Set Universal mode
(factory default setting on standard versions)
Set PROFINET mode (factory default setting on
2
PROFINET versions)
Set EtherNet/IP mode
Operation with default IP address
Resetting the IP configuration
Operation in Unmanaged mode
1
On the 20xx/21xx/22xx/23xx/26xx/27xx versions, the two LEDs (LNK/ACT and SPD) of port 1 and 2 re-
spectively are used – the reading direction on the device is from top to bottom (LED 1 = LNK/ACT of port
1, LED 4 = SPD of port 2).
On the 24xx/25xx versions, the four LNK/ACT LEDs of port 1-4 are used – the port number corresponds to
the LED number.
2
The 20xx/21xx versions do not support PROFINET mode.
4.2.4
Exiting Smart mode
•
To exit this mode, press and hold down the Smart Mode button for at least five seconds.
The previously selected operating mode is saved and activated as soon as you release
the Smart Mode button.
4.2.5
Operation in Universal mode
Activating Universal mode resets the device as described in
state" on page
42. This deletes any configurations stored on the device. An automation pro-
tocol is not activated in this mode. The initial IP configuration is activated (see Section
IP configuration in the delivery state" on page
1
1
LED 1
LED 2
On
Off
Off
On
On
On
Off
Off
Off
On
On
On
Off
On
"Configuration in the delivery
41).
1
1
LED 3
LED 4
Off
Off
Off
Off
Off
Off
On
Off
On
Off
On
Off
Off
On
"Initial
108997_en_04