Removing The Device - Phoenix Contact FL SWITCH 2000 Series Installation And Startup Manual

FL SWITCH 2000 / FL NAT 2000
32 / 226
PHOENIX CONTACT
Mounting:
• Place the module onto the DIN rail from above (A1). The upper holding keyway of the
module must be hooked onto the top edge of the DIN rail. Push the module from the
front towards the mounting surface (A2).
• Once the module has been snapped on properly, check that it is fixed securely on the
DIN rail.
Figure 317 Snapping the device onto the DIN rail
Removal:
• Pull down the positive latch using a suitable tool (e.g., screwdriver). On the 16-port
devices, the positive latch remains snapped out. Then slightly swivel the bottom of the
device away from the DIN rail (B1). Lift the device upwards away from the DIN rail (B2).
Figure 318

Removing the device

108997_en_04