Operation In Profinet Mode; Operation In Ethernet/Ip Mode; Operation With Default Ip Address; Resetting The Ip Configuration - Phoenix Contact FL SWITCH 2000 Series Installation And Startup Manual

108997_en_04
4.2.6

Operation in PROFINET mode

Activating PROFINET mode resets the device as described in
state" on page 42 and activates the PROFINET device and DCP functions for IP address as-
signment. In addition, the "PROFINET" Quality of Service profile is activated. This deletes
any configurations stored on the device. The PROFINET automation protocol is activated in
this mode.
In PROFINET mode, the initial IP configuration (see Section
delivery state" on page 41) is not supported and therefore deactivated.
4.2.7

Operation in EtherNet/IP mode

Activating EtherNet/IP mode resets the device as described in
state" on page 42 and activates the IGMP snooping and IGMP querier (version 2) functions.
In addition, the "EtherNet/IP" Quality of Service profile is activated. This deletes any config-
urations stored on the device. The initial IP configuration is activated (see Section
configuration in the delivery state" on page
4.2.8

Operation with default IP address

For operation with a default IP address, the device is assigned a fixed IP address. A DHCP
server is activated on the switch and assigns an IP address to the connected PC via DHCP.
To start up the device with a default IP address, activate the "Operation with static IP ad-
dress" Smart mode as described in Section
1. In the network settings on your PC, select the "Obtain an IP address automatically" op-
tion.
Deactivate all other network interfaces on your PC.
2. Connect the switch to your PC.
3. Select the "Operation with default IP address" Smart mode as described in Section
ing Smart mode" on page
4. The switch assigns an IP address to the PC via DHCP.
5. The switch can now be accessed via IP address "192.168.0.254".
Set the desired IP address via web-based management.
4.2.9

Resetting the IP configuration

When the "Reset IP configuration" Smart mode is activated, the IP address, subnet mask,
and default gateway are reset to 0.0.0.0 and BootP is activated. Any other configurations
stored on the device are retained and are not deleted. The initial IP configuration is activated
(see Section "Initial IP configuration in the delivery state" on page
41).
"Using Smart mode" on page
43.
Startup and function
"Configuration in the delivery
"Initial IP configuration in the
"Configuration in the delivery
"Initial IP
43.
41).
45 / 226
PHOENIX CONTACT
"Us-