Using Smart Mode - Phoenix Contact FL SWITCH SMN 6TX/2POF-PN User Manual

Smart Managed Compact Switch
20
PHOENIX CONTACT
3.2

Using Smart mode

Smart mode enables the user to change the operating mode of the switch without having
access the management interface.
The FL SWITCH SMN offers the following setting options via Smart mode:
– Reset to the default settings
– Set PROFINET mode
– Exit Smart mode without changes
3.2.1 Activating Smart mode
The mode button is used to call/exit Smart mode and to select the desired setting. The three
mode LEDs indicate the mode that is currently set and the mode which will apply when ex-
iting Smart mode.
3.2.1.1 Calling Smart mode
• Following the switch boot phase, as soon as the three mode LEDs go out, press and
hold down the mode button for more than five seconds. If Smart mode is active, the
three LEDs will flash.
• When Smart mode is started, the switch is initially in the "Exit without changes" state.
3.2.1.2 Selecting the desired setting
• To select the various settings, press the mode button briefly and select the desired op-
erating mode.
3.2.1.3 Exiting Smart mode
• To exit, press and hold down the mode button for at least five seconds. The previously
selected operating mode is saved.
3.2.1.4 Possible operating modes in Smart mode
The FL SWITCH SMN supports the selection of the following operating modes in Smart
mode (see also example below):
Table 3-1 Operating modes in Smart mode
Mode
Exit Smart mode without changes
Reset to the default settings
Set PROFINET mode
ACT SPD
LED 1 LED 2
Off Off
Off On
Off On
FD
LED 3
On
Off
On
8089_en_03