Assembly - ELECTRO FREEZE GENESIS Series Operator's Manual

ELECTRO FREEZE Soft Serve Model GEN-5400
8

Assembly

DO NOT
LUBRICATE
CUP SEAL
LUBRICATE
LUBRICATE
Figure 8-1 Shaft Seal Assembly
Figure 8-2 Beater Shaft
Assembly
PROPER BLADE
INSTALLATION
IS WITH FLAT SIDE
AGAINST CYLINDER
WALL.
Figure 8-3 Scraper Blade Installation
184297
CUP SEAL
WASHER
O-RING
Correct assembly of the freezer is
essential to prevent leakage of the
product and damage to the freezer. To
assemble the freezer you will need an
approved lubricant (such as Petrol-Gel).
Make sure all parts of the assemblies
have been washed and sanitized before
assembling. Persons assembling the
freezer must first wash and sanitize their
hands and forearms with an approved
sanitizer.
CAUTION
To avoid electrical shock or
contact with moving parts,
make sure all switches are
in the "OFF" position and
that the main power supply
is disconnected. Some
freezers have more than
one disconnect switch.
1. To assemble the shaft seal, install
the cup seal and O-ring on the plastic
washer (see figure 8-1). Apply a light
amount of approved sanitary lubricant
(such as Petrol-Gel) to the O-ring and the
face of the plastic washer opposite the
bell portion of the seal. Do not allow any
lubricant to come into contact with the
bell-shaped rubber portion of the seals.
2. Install the shaft seal over the rear
of the beater shaft, with the bell-shaped
portion facing the rear as shown in figure
8-2.
3. Place the scraper blades on the
beater shaft, making sure the blades are
installed properly (see figure 8-3).
4. Insert the assembled beater shaft
into the cylinder by placing the rear blade
on the bottom of the cylinder. This will
center the beater and allow alignment
with the drive coupling. Rotate the beater
assembly while pushing, until the shank
has engaged the coupling. Repeat for
second cylinder assembly.
– continued
27