Priming - ELECTRO FREEZE GENESIS Series Operator's Manual

ELECTRO FREEZE Soft Serve Model GEN-5400
9.1 Sanitizing
NOTE: Some sanitizer will remain in
13. Press L2 & R2 keys to turn the MTS
14. Remove the pickup tubes, holding the
9.2

Priming

Priming the freezer removes all excess air and sanitizer from the freezing cylinder
and sets the proper overrun for the first cylinder of product.
1. Wash and sanitize your hands and
forearms.
2. Holding the top 6-inch (15cm) portion
only, insert each pickup tubes into the
sanitized mix tank through the small hole
in the rear cover and set tanks in the
cabinet.
3. Slide each boot seal down on the mix
tank cover.
4. Fill the mix tanks with mix and install
the front covers.
5. Insert each sanitized mix probes
through the large hole in the rear cover,
and connect the probe cords to the
CLAMP-SOFT HOSE
O-RING
PORT-AIR/MIX INLET
CLIP-TUBE RETAINER
CLAMP-SOFT HOSE
ARM-SWING CLAMP
SHOE-SPRING 18
KNOB-HAND
COVER-MTS
TUBE-ASSY
PICKUP
DUCKBILL-INLET
Figure 9-1
184297
(continued)
hoses and cylinder.
pumps "OFF".
top 6" portion only.
15. Remove the mix tanks and empty any
remaining sanitizer.
probes and to the back of the cabinet.
6. Close the cabinet door.
7. Place an empty container under the
dispense head on the drip tray.
8. Pull up the air bleed plugs
9. Open the side spigots.
10. Press L2 & R2 keys to turn the MTS
pumps "ON" allowing the mix to push the
remaining sanitizer from the freezer.
11. Close the spigots one at a time when
pure mix is coming out.
Failure to completely remove
sanitizer or water from the freezing
cylinder before placing in "FREEZE"
AIR METER
will cause the scraper blades to break
TUBE-AIR
RETAINER-AIR TUBE
and damage the freezer.
CLAMP-SOFT HOSE
HOSE-MIX BRAIDED
12. Allow the MTS to fill the cylinder
SUPPORT-ROLLER
BEARING
until mix flows from the bottom of the air
HOSE-TRANSFER
RED LINE
bleed plug openings in the bottom of the
ROLLER-ASSY
COMPLETE
dispehnse head, close the air bleed plugs.
SHOE-ROLLER
Wait for the MTS to fill the cylinders and
shut off.
13. After the cylinders are pressurized
and the MTS has cycled off
(approximately 30 seconds) Press the left
and right "Freeze" keys.
14. Allow the freezer to cycle for 15
minutes. The product is now ready to
serve.
Important:
33