Table of Contents
Advertisement
1.2.2
Card Access System
1.3
Configurable Features
1.3.1
PC Configurator Software
Version 2.2
LT-980
The Wiegand compatible access card has 26 bits of information embedded onto
the card. The card reader reads and registers the card information and sends it
back to the controller in a serial bit stream.
The Mircom Card Access System supports a proprietary 37-bit encoding
technology and a 26-bit SIA standard format, and consists of a maximum of 63
Card Access Controllers networked together. Each Card Access Controller can
have two card readers. The Card Access System provides an optional battery
backup and a real time clock.
The Card Access System integrates with the TX3 Telephone Access system by
utilizing a common network for both Telephone Access and Card Access
Systems.
A PC provides configuration and on-line monitoring of the Card Access System
and the Telephone Access System status. Once the system is configured, the PC
is not required.
The system is configured by connecting the inputs and outputs to device access
points, and using the configurator software to establish the correlations between
these inputs and outputs.
Additional physical configuration is required using the dip switches and jumpers
on the controller. DIP switches set the Card Access Controller network address.
Jumper settings set the controller for firmware updates.
The Configurator Software TX3-MSW is a combined Telephone Access System
and Card Access System configurator that uses a common database. Once the
controller is installed the system applies its default values. Use the configurator
software to fully configure the system. See the following documentation:
•
LT-995 Configuration and Administration Guide
•
LT-973 TX3 Software Guide
TX3-CX Card Access System Installation and Operation Manual
Copyright 2015
Welcome
9 (61)
Advertisement
Table of Contents
Need help?
Do you have a question about the TX3 Series and is the answer not in the manual?
Questions and answers