Mircom TX3 Series Installation And Operation Manual page 6

List of Figures
Figure 1 Basic Card Access System
Figure 2 Card Access System using an RS-485 network
Figure 3 Card Access System using an ethernet TCP/IP network. Controllers connected
to an ethernet network are Master Nodes.
Figure 4 Card Access System using both ethernet and RS-485 networks
Figure 5 Controller Back Cover Dimensions and Optional Component Location
Figure 6 Modem Board Location
Figure 7 IP Module Board Location
Figure 8 MD-993 Module
Figure 9 Controller Board Connection Locations
Figure 10 Power Supply
Figure 11 Controller Board Battery Wiring
Figure 12 RS-485 Connections
Figure 13 Controller Board Input Terminals
Figure 14 Input Terminal Sample Connections
Figure 15 Input - Supervised for Open
Figure 16 Input - Supervised for Short
Figure 17 Input - Supervised for Open and Short
Figure 18 Controller Output Terminal Sample Connections
Figure 19 Outputs 7 and 8 Sample Connections
Figure 20 Card Reader Connections
Figure 21 Controller Board Card Reader Connectors
Figure 22 Location of Jumpers JW1 to JW5 and Switches SW1 and SW2
6 (61)
LT-980
35
38
39
TX3-CX Card Access System Installation and Operation Manual
Copyright 2015
10
11
34
35
37
38
40
40
42
42
43
45
46
46
11
12
44
51
32
Version 2.2