Table of Contents
Advertisement
54 (61)
LT-980
•
Ensure the Configurator software is set with the correct controller network
address.
•
Ensure that your PC and the Configurator are set with the correct date and
time.
To start the configuration
1.
Connect the PC to the controller using the USB port.
2.
Launch the Configurator and click Connect. Once connected the
connection icon appears in the Configurator tool bar.
3.
Configure the Card Access system using the instructions in the
Configurator Software Program TX3-MSW or the LT-995 Configuration
and Administration Guide.
TX3-CX Card Access System Installation and Operation Manual
Copyright 2015
Installation and Setup
Version 2.2
Advertisement
Table of Contents
Need help?
Do you have a question about the TX3 Series and is the answer not in the manual?
Questions and answers