Table of Contents
Advertisement
3.9
Turning on the Controller
3.9.1
Default Configuration Values
3.10
Updating Firmware
52 (61)
LT-980
JW3, JW4 and JW5. JW3, JW4 and JW5 are not used and are open by default.
JW6. JW6 is not used and by default is open.
Before you turn on the controller ensure that the all connections adhere with the
correct operation of the devices. For example, a magnetic lock requires power in
the default state.
Once the controller is turned on, you must begin the configuration. For detailed
information on how to configure the controller see LT-995 Configuration and
Administration Guide.
Once the controller is on, it operates according to its preset default configuration
values. When the configurator software first starts, it uses the default values and
adopts these values as its initial settings.
The default configuration values are adopted only when the following situations
occur:
•
turning the system on for the first time
•
memory corruption
•
program upgrade
You can update the firmware on your panel with the TX3 Configurator software
by using one of the following methods.
•
Firmware Upgrade Wizard
•
Network Firmware Upgrade
The Firmware Upgrade Wizard can be used to update only one panel at a time. It
will work on any panel. This method does not work on 64-bit versions of
Windows.
The Network Firmware Upgrade procedure can update more than one panel at the
same time. In order to use the Network Firmware Upgrade, all of the panels must
already have firmware that supports this feature installed on them.
TX3-CX Card Access System Installation and Operation Manual
Copyright 2015
Installation and Setup
Version 2.2
Advertisement
Table of Contents
Need help?
Do you have a question about the TX3 Series and is the answer not in the manual?
Questions and answers