Operation - Nakayama MB6000 Manual

EN

OPERATION

Handlebar height adjustment (Fig. 16)
Caution: Before adjusting the handlebar, place the tiller on firm level ground to prevent the handle
from collapsing accidentally.
• To adjust the handlebar height, loosen the adjuster, select the appropriate place and tighten the
adjuster.
(1) Adjuster
Tilling depth adjustment (Fig. 17)
• Install the hitch attachment in the hitch box with a hitch pin.
• Adjust the tilling depth by removing the pin, loosening the bolt securing the drag bar and sliding the
drag bar up or down as necessary.
(1) Hitch box (2) Hitch pin
(4) Drag bar (5) Pin
Clutch operation (Fig. 18)
Caution: Reduce engine rpm before operating the main clutch.
• The clutch engages and disengages the power from the engine to the transmission.
• When the clutch lever is squeezed the clutch is engaged and power is transmitted. Squeeze the lever,
the tool will be rotated.
• When the lever is released, the clutch is disengaged and power is not transmitted, release the clutch
lever, the tool will be stopped.
(1) Clutch lever (2) Engaged
Gear selection (Fig. 19)
The machine has 3 gears: F (forward), R (reverse) and N (neutral).
To shift gears:
• Return the throttle lever to the extreme right.
• Release the clutch lever to disengage the clutch.
• Move the gear shift lever to the desired gear position.
Note: If the shift lever will not engage the desired gear, squeeze the clutch lever and move the tiller
slightly to reposition the gears.
• Squeeze the clutch lever to engage the clutch.
Front wheel (Fig. 20)
• Use a front wheel to move the tiller on the road.
• Lift the handlebars up and let the front wheel touch the ground.
• When the tiller is used in the field, move the wheel up by replacing the lock pin.
(1) When used in the field
7
(3) Locking pin
(3) Disengaged
(2) Lock pin (3) When moved on the road
WWW.NIKOLAOUTOOLS.GR
Fig. 16
Fig. 17
Fig. 18
Fig. 19
Fig. 20