Pre-Operation Check; Engine Oil; Transmission Gear Oil - Nakayama MB6000 Manual

(1) frame serial number (2)fuel tank (3)transmission oil filler cap
(4) mud fender (5) wheel (6) drag bar
(7) connecting bar (8) handle bar (9) throttle control
(10) handle height adjuster (11) safety bar (12) engine switch (13)clutch
(14) shift level (15) belt cover (16) blade

PRE-OPERATION CHECK

1.ENGINE OIL

CAUTION: Running the engine with low oil level will cause serious engine damage.
·Remove the oil filler cap and wipe the dipstick clean.
·Insert the dipstick into the oil filler neck, but do not screw it in .
·If the level is low, fill to the top of the oil filler neck with the recommended oil.
Use high-detergent, premium quality 4-stroke engine oil, certified to meet or exceed U.S.
automobile manufacturer's requirement for API Service Classification SG, SF.
CAUTION: Using nondetergent oil or 2-stroke engine oil could shorten the engine's service life.
SAE 10w-30 is recommended for general, all temperature use. Other viscosities shown in the
following chart might be used when at the average temperature in your area is within the indicated
range.
(1) OIL FILLER HOLE
(2) UPPER LEVEL
(3) LOWER LEVEL

2.TRANSMISSION GEAR OIL

Place the tiller on a level surface and remove the oil filler cap.
The oil should be level with the lower edge of the oil filler hole.
Add high quality engine oil if the level is low.
(1) OIL FUEL HOLE
26
.N T .
WWW AKAYAMA OOLS COM