Intended Use; Packaging Contents; Assembly Steps - Nakayama MB6000 Manual

EN
• Allow the engine to cool before storing in any enclosure.
• To reduce the fire hazard, keep the engine, exhaust muffler, battery compartment and petrol storage area free of vegetative material and excessive grease.
• Replace worn or damaged parts to ensure safety.
• If the fuel tank has to be drained, this must be done outdoors.
• Keep the tiller in good operating condition. Operating the tiller when it is in poor condition could result in serious injury.
• Ensure that all safety devices are in good working order and that warning labels are in place.

INTENDED USE

• The tiller is suitable for the cultivation of sandy and clay soil as well as for cultivating paddy fields with the depth of the water surface to the hard layer being
not more than 250mm.
• For weedy and deep plots, remove the weeds before using the tiller to cultivate the land.
ASSEMBLY INSTRUCTIONS (SEE APPENDIX, PAGES 69-76)

Packaging contents

Assembly steps

Remove all the items from the box, remove the plastic bag and take the following steps to assemble the machine.
Each of the following numbers corresponds to the respective picture found at the appendix (see pages 69-76).
1) Install the wheels.
2) Install the depth adjuster.
3) Adjust the safety element on the depth adjuster.
4) Remove the screws from the belt cover.
5) Remove the belt cover.
6) Remove the screws from the belt guide.
7) Remove the belt guide.
8) Remove the screws from the protective plate of the belt guide and remove the plate.
9) Remove the screws from the gearbox cover.
10) Remove the safety element from the gear shaft.
11) Install the gear lever together with the locker bar.
12) Reinstall the safety element on the gearbox lever.
13) Secure the gear lever in place.
14) Adjust the screws on the gearbox.
15) Unscrew the locker bar screw and install the plate.
16) Adjust the belt guide plate and tighten the screws.
17) Adjust the belt guide.
18) Tighten the screws of the belt guide.
19) Adjust the two fenders with screws and nuts.
20) Tighten the screws and nuts on the fenders securely.
21) +22) Adjust the connection plate on the fenders.
23) Tighten the screws on the connection plate.
24) Remove the screws from the belt guide plate.
25) Adjust the protective cover of the guide.
26) Tighten the screws on the cover.
Caution! Make sure that the fenders, the connection plates and the protective cover are correctly and securely fitted before using the machine.
4
2 safety protection boards
Gasoline engine body
Depth regulator
Standing pipe joint Front wheel
Connecting plate for safety
2 tyres
protection boards
Fig. 3
WWW.NIKOLAOUTOOLS.GR