Engine Oil Change - ESAB Ruffian ES 150G EDW Instruction Manual

8 MAINTENANCE
1-Perform these procedures more frequently under severe, dusty, dirty conditions.
2-Contact Kohler authorized dealer to perform this service.
NOTE!
This engine should be operated in its original configuration below 4000 ft. (1219
meters). Operating this engine with the wrong engine configuration at a given altitude
may increase its emissions, decrease fuel efficiency and performance, and result in
damage to the engine. If this engine is operated at an altitude of 4000 ft. (1219
meters) or above, a high-altitude carburetor kit is required.
Kohler's part numbers
Spark Plugs----------------------------------25 132 19-S
Air Filter Element ---------------------------17 083 18-S
Fuel Filter-------------------------------------25 050 21-S
High altitude kit (4000~8000FT) ------- 17 755 10-S
NOTE!
See CH440 Kohler engine manual for complete engine care. Give engine
specifications and serial number when ordering parts.
NOTE!
REPAIRS/SERVICE PARTS Kohler genuine service parts can be purchased from
Kohler authorized dealers. To find a local Kohler authorized dealer visit
https://kohlerpower.com/en/engines/dealers or call 1-800-544-2444 (U.S. and
Canada).
8.1.1

Engine Oil Change

NOTE!
Dispose of used oil in accordance with local ordinances.
NOTE!
The Kohler CH440 has an Oil Capacity (Refill) of 1.16 U.S.qt (1.1L).
Inspect equipment before starting it. If any problems are found, do not use the equipment until
fixed properly. The oil level needs to be checked daily. See the section 4.5 Engine prestart
checks to find the position of the oil dipstick and the drain plugs at the engine.
1. Make sure the equipment is stopped and the engine is still warm and on a level surface.
2. Clean the area around oil dipstick and drain plugs. The engine has one drain plug at each
side.
3. Place a drain pan underneath any of the crankcase's drain plug.
4. Remove the drain plug and the oil dipstick and drain the oil completely.
5. Reinstall the drain plug.
6. Fill crankcase with new oil to the specified level on the dipstick.
7. Reinstall the oil dipstick and tighten it secure
0463 905 001
- 38 -
© ESAB AB 2022