ESAB Ruffian ES 150G EDW Instruction Manual page 42

8 MAINTENANCE
2. Remove the ten screws holding the top cover and remove the panel.
3. Clean the welder and front panel compartment of the engine driven welder,
using dry compressed air with reduced pressure.
4. Make sure that there is no dust left on any part of the welder module.
5. After having finished cleaning the welder module, reattach the top cover with
the ten screws.
6. Tighten the screws on the top cover with 3 Nm ± 0.3 Nm (26.6 in lb. ± 2.6).
0463 905 001
- 42 -
© ESAB AB 2022