ESAB Ruffian ES 150G EDW Instruction Manual page 26

5 INSTALLATION
NOTE!
Each Handle Assembly is made up of an upper tubular part and a lower tubular
part. The upper part fits into the lower part and each part have a bracket to be fixed
to the frame with two screws. This allows the upper part of the Handle Assembly to
be removable once installed on the machine.
4. Identify the right and left lower parts of each Handle Assembly.
5. Fasten the brackets of the lower parts to the frame using two M6 x 16mm Hexagon pan
head screws at each side.
6. Fasten the lower ends of the Handles to the bottom of the Frame using a M6 x 70mm
Bolt, 6 mm flat washer, 6 mm Spring Washer, and M6 Nut at each side.
7. Install the upper parts of each Handle Assembly and secure them to the frame using two
M6 x 16mm Hexagon pan head screws at each side.
8. Make sure that all the hardware is tighten securely
0463 905 001
- 26 -
© ESAB AB 2022