EMG Lord Black Aluminium Operating Instructions Manual page 121

CONTROL DISPLAY
SHIMANO STEPS SCE 6010 AND SCE 6000 UNITS
Features
High shifting performance system (In the case of electronic gear shifting) This system
uses accurate sensors to enable shifting gears by providing the most appropriate level
of power assistance carefully adjusted by computer controls.
Full Automatic Shifting (In the case of electronic 8-speed gear shifting). The sensors
detect riding conditions, whether you are riding up a hill against the wind, or on flat
ground with no wind; the automatic gear shifting system uses computer controls to
make your ride more pleasant.
Start mode (In the case of electronic gear shifting. This function allows automatic
shifting down to a preset gear when you stop the bicycle such as at traffic lights so
that you can start traveling at a light gear.
If, while the bicycle is stopped, you shift to a gear lower than the set gear, the system
will not automatically shift up.
Light off road Sporty, provides powerful assistance. Can only be used when set by the
manufacturer of the completed bicycle.
Walk assistance function (Walk assist mode)
The Walk assist mode function may not be able to be used in certain regions.
Some of the functions listed above can only be used once the firmware has been
updated. If this is the case, consult the place of purchase, and carry out the firmware
updates
Riding the bicycle
Turn on the power.
Do not place your foot on the pedals when turning the power on. A system error may
result.
Power cannot be turned on while charging.
Select your preferred assist mode.
Assistance will start when the pedals start turning. Change the assist mode in
accordance with the riding conditions.
Turn the power off when parking the bicycle.
Do not place your foot on the pedals when turning the power off. A system error may
result.
Assist mode
You can select a SHIMANO STEPS assist mode for each particular application.
34 - EN