Control Display - EMG Lord Black Aluminium Operating Instructions Manual

CONTROL DISPLAY

DP E06 LED CONTROL DISPLAY
The LED control display operates the drive
system and is located on the handlebar
on the left side, near the grip.
1. Control Unit Function Overview
2. Operations
2.1 Power button ON/OFF
Push Power On/Off button for 2 seconds
to switch on/off the LED control unit and
electric drive system.
The system will automatically turn off if left
idling for more than 5 minutes.
2.2 Pedal assistance (PAS) level selection
Once turned on, the system switches
todefault Level 0.
Push "+" or "-"
betweendifferent levels of assistance. The
LED light on top of each number indicates
the level of assistance selected.
buttons to switch
If there is no LED light indication, it means
you are on default mode or have selected
Level 0 and the electric system does not
offer any assistance. The ebike behaves
similar to a standard bike. You will feel the
electric assistance kicking in once selecting
again between Levels 1 up to 5.
2.3 Light ON/OFF
With the display switched on, press the
button for 2 seconds to turn on/off the
headlight and taillight.
2.4 Walk Assist Function
The ebike comes equipped with walk assist
function.
This feature propels forward your ebike with
a constant speed of 6 km/h without
pedaling and requires to hold it balanced
when walking along side it. It comes very
handy when needing to push it up a steep
incline.
Hold the "-" button to activate the walk
assist.
This function remains activated as long as
you keep hold on the "-" button and
deactivates the moment you stop holding
it.
2.5 Battery charge level
The LED bar on top will be completely lit if
the battery is fully charged and the LED
indicators will gradually switch off when the
battery charge level starts dropping.
22 - EN