Ipv6 Neighbor Setup - ZyXEL Communications GS1920v2 Series User Manual

Figure 92 SYSTEM > IPv6 > IPv6 Neighbor Discovery > IPv6 Neighbor Discovery Setup > Edit
The following table describes the labels in this screen.
Table 47 SYSTEM > IPv6 > IPv6 Neighbor Discovery > IPv6 Neighbor Discovery Setup > Edit
LABEL
Interface
DAD Attempts
NS Interval
Reachable
Time
Apply
Clear
Cancel

22.8 IPv6 Neighbor Setup

Use this screen to view and configure static IPv6 neighbor entries in the Switch's IPv6 neighbor table to
store the neighbor information permanently. Click SYSTEM > IPv6 > IPv6 Neighbor Setup to display the
screen as shown next.
Figure 93 SYSTEM > IPv6 > IPv6 Neighbor Setup
The following table describes the labels in this screen.
Table 48 SYSTEM > IPv6 > IPv6 Neighbor Setup
LABEL
Index
Interface
Chapter 22 IPv6
DESCRIPTION
Select the IPv6 interface you want to configure.
The Switch uses Duplicate Address Detection (DAD) with neighbor solicitation and advertisement
messages to check whether an IPv6 address is already in use before assigning it to an interface.
Specify the number of consecutive neighbor solicitations (from 0 to 600) the Switch sends for this
interface. Enter 0 to turn off DAD.
Specify the time interval (from 1000 to 3600000 milliseconds) at which neighbor solicitations are re-
sent for this interface.
Specify how long (from 1000 to 3600000 milliseconds) a neighbor is considered reachable for this
interface.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
DESCRIPTION
This is the interface index number.
This is the name of the IPv6 interface you created.
GS1920v2 Series User's Guide
135