ZyXEL Communications GS1920v2 Series User Manual page 166

Figure 112 PORT > Link Aggregation > Link Aggregation Control Protocol
The following table describes the labels in this screen.
Table 76 PORT > Link Aggregation > Link Aggregation Control Protocol
LABEL DESCRIPTION
Active Enable the switch button to enable Link Aggregation Control Protocol (LACP).
System Priority LACP system priority is a number between 1 and 65535. The switch with the lowest system priority
(and lowest port number if system priority is the same) becomes the LACP "server". The LACP
"server" controls the operation of LACP setup. Enter a number to set the priority of an active port
using Link Aggregation Control Protocol (LACP). The smaller the number, the higher the priority
level.
Use this section to enable LACP on trunks.
Group ID The field identifies the link aggregation group, that is, one logical link containing multiple ports.
LACP Active Select this option to enable LACP for a trunk.
Use this section to configure LACP timeout on ports.
Port This field displays the port number.
Chapter 30 Link Aggregation
GS1920v2 Series User's Guide
166