Technical Reference; Mstp Network Example - ZyXEL Communications GS1920v2 Series User Manual

Table 151 SWITCHING > Spanning Tree Protocol > MSTP > MSTP Port Setup (continued)
LABEL
Apply
Cancel

46.11 Technical Reference

This section provides technical background information on the topics discussed in this chapter.

46.11.1 MSTP Network Example

The following figure shows a network example where two VLANs are configured on the two switches. If
the switches are using STP or RSTP, the link for VLAN 2 will be blocked as STP and RSTP allow only one link
in the network and block the redundant link.
Figure 201 STP/RSTP Network Example
With MSTP, VLANs 1 and 2 are mapped to different spanning trees in the network. Therefore traffic from
the two VLANs travel on different paths. The following figure shows the network example using MSTP.
Figure 202 MSTP Network Example
Chapter 46 Spanning Tree Protocol
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
GS1920v2 Series User's Guide
287