Lldp-Med Location; Add/Edit Lldp-Med Location - ZyXEL Communications GS1920v2 Series User Manual

Table 88 PORT > LLDP > LLDP MED > LLDP-MED Network Policy > Add/Edit (continued)
LABEL
Apply
Clear
Cancel

31.10 LLDP-MED Location

Click PORT > LLDP > LLDP MED > LLDP-MED Location to display the screen as shown next.
Figure 129 PORT > LLDP > LLDP MED > LLDP-MED Location
The following table describes the labels in this screen.
Table 89 PORT > LLDP > LLDP MED > LLDP-MED Location
LABEL
Index
Port
Location
Coordinates
Civic Address
ELIN Number
Add/Edit
Delete

31.10.1 Add/Edit LLDP-MED Location

To access this screen, click the Add/Edit button or select an entry from the list and click the Add/Edit
button.
Chapter 31 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
DESCRIPTION
This lists the index number of the location configuration. Click an index number to view or edit
the location.
This lists the port number of the location configuration.
This field displays the location configuration information based on geographical coordinates
that includes longitude, latitude, altitude and datum.
This field displays the Civic Address for the remote device using information such as Country,
State, County, City, Street, Number, ZIP code and additional information.
This field shows the Emergency Location Identification Number (ELIN), which is used to
identify endpoint devices when they issue emergency call services. The valid length is form
10 to 25 characters.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click Add/Edit to add a new location or edit a selected one.
Select the locations that you want to remove, then click Delete.
GS1920v2 Series User's Guide
189