Ipv6 Neighbor Setup - ZyXEL Communications GS2220 Series User Manual

Table 45 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Discovery Setup (continued)
L ABEL
NS Interval
Reachable
Time
8.10.9 IPv6 Ne ig hb o r Se tup
Use this screen to create a static IPv6 neighbor entry in the Switch's IPv6 neighbor table to store the
neighbor information permanently. Click the link next to
screen to display the screen as shown next.
Fig ure 104
The following table describes the labels in this screen.
Table 46 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup
L ABEL
Interface Type
Interface ID
Neighbor
Address
MAC
Add
Cancel
Clear
Index
Chapter 8 Basic Setting
DESC RIPT IO N
This field displays the time interval (in milliseconds) at which neighbor solicitations are re-sent for
this interface.
This field displays how long (in milliseconds) a neighbor is considered reachable for this interface.
Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Setup
DESC RIPT IO N
Select the type of IPv6 interface for which you want to configure. The Switch supports the VLAN
interface type for IPv6 at the time of writing.
Specify a unique identification number (from 1 to 4094) for the interface.
A static IPv6 neighbor entry displays in the
the interface ID is also created in the
To have IPv6 function properly, you should configure a static VLAN with the same ID number in the
Adva nc e d Applic a tio n
Specify the IPv6 address of the neighboring device which can be reached through the interface.
Specify the MAC address of the neighboring device which can be reached through the
interface.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the
to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
Click to reset the fields to the factory defaults.
C le a r
This is the interface index number. Click an index number to change the settings.
GS2220 Series User's Guide
IPv6 Ne ig hb o r Se tup
Ma na g e m e nt
>
Ba sic Se tup
> screens.
VL AN
link on the top navigation panel to save your changes
Sa ve
129
in the
IPv6 C o nfig ura tio n
>
IPv6 Ne ig hb o r T a b le
screen.
Inte rfa c e Se tup
screen only when