Ipv6 Neighbor Setup - ZyXEL Communications XS1930-12F User Manual

The following table describes the labels in this screen.
Table 46 Basic Setting > IPv6 > IPv6 Configuration > IPv6 Prefix Setup
LABEL
Interface
Prefix
Prefix Length
Valid Lifetime
Preferred Lifetime
Flags
Add
Cancel
Clear
Index
Interface
Prefix/Prefix Length
Valid Lifetime
Preferred Lifetime
Delete
Cancel

8.10.11 IPv6 Neighbor Setup

Use this screen to create a static IPv6 neighbor entry in the Switch's IPv6 neighbor table to store the
neighbor information permanently. Click the link next to IPv6 Neighbor Setup in the IPv6 Configuration
screen to display the screen as shown next.
Chapter 8 Basic Setting
DESCRIPTION
Select the IPv6 interface you want to configure.
Set the IPv6 prefix that the Switch includes in router advertisements for this interface.
Set the prefix length that the Switch includes in router advertisements for this interface.
Specify how long (from 0 to 4294967295 seconds) the prefix is valid for on-link
determination.
Specify how long (from 0 to 4294967295 seconds) that addresses generated from the prefix
remain preferred.
The preferred lifetime cannot exceed the valid lifetime.
Select No-Autoconfig Flag to not allow IPv6 hosts to use this prefix.
Select No-Onlink Flag to not allow the specified prefix to be used for on-link determination.
Select No-Advertise Flag to set the Switch to not include the specified IPv6 prefix, prefix
length in router advertisements for this interface.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if
it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to reset the fields to the factory defaults.
This is the interface index number. Click an index number to change the settings.
This is the name of the IPv6 interface you created.
This field displays the IPv6 prefix and prefix length that the Switch includes in router
advertisements for this interface.
This field displays the IPv6 prefix valid lifetime.
This field displays the preferred lifetime of an IPv6 address generated from the prefix.
Select an entry's check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Check the entries that you want to remove in the Delete column and then click Delete to
remove the selected entries from the summary table.
Click Cancel to clear the Delete check boxes.
XS1930 Series User's Guide
114