Configuration Procedure - Honeywell UDC2800 Product Manual

Chapter 4 - Configuration
Setup Group
Auxiliary Calib
(Calibration)
Status

Configuration Procedure

Table 4-2: Configuration Procedure
Step Operation
1 Enter Set Up Mode Setup key
2 Select any Set Up
Group
71
Function Prompts
Introduction
Each of the Set Up groups and their functions are pre-configured at
the factory.
The factory settings are shown in Table
Prompts through Table
If you want to change any of these selections or values, follow the
procedure in Table Configuration
the keys to press to get to any Set Up group and any associated
Function parameter prompt.
Procedure
See Operator Interface
Press
Setup key or
Increment key or
Decrement key
Security Group Function
Display Group Function
Procedure. This procedure tells you
for more information of keys.
Result
Enter in the first set up group,
Security.
Sequentially displays the other set
up groups shown in the prompt
hierarchy. See Configuration Prompt
Hierarchy for more information.
You can also use the Increment key
or Decrement keys to scan the set
up groups in both directions. Stop
at the set up group title that
describes the group of parameters
you want to configure. Then proceed
to the next step.
Prompts.