Honeywell UDC2800 Product Manual page 223

Chapter 5 - Monitoring and Operating the Controller
Prompt
Segment 8 SP
Segment 8 Time
Table 5-25: Run/Monitor Functions
Function
Set the Local
Setpoint
Run State
Hold State
223
Function
Soak SP
Soak Time
Run/Monitor the program
Prior to running the program, make sure all the "SP Program
Function" prompts under the Set Up group "SP Ramp/Program" have
been configured with the required data.
"Hold" appears in the Middle Display indicating that the program is
in the HOLD state.
ATTENTION: SP Program parameter can only be changed
before the program is started (run or hold), or after the
program is terminated, except for SP Program Function and
Key Reset/Rerun.
Run/Monitor functions
The following table lists all the functions required to run and monitor
the program.
Press Result
Lower Until you see " SP" appears in the Lower Display.
Display key
Increment To set the Local Setpoint value to where you want the
key or program to start out.
Decrement
key
Run/Hold Initiates the setpoint program.
(Setup key
" Run " appears in the Middle Display indicating that
and
the program is running.
Increment
key)
Run/Hold Holds the setpoint program.
(Setup key
" Hold " appears in the Middle Display indicating that
Segment Value
8
8