Honeywell UDC2800 Product Manual page 249

Chapter 7 - Output Calibration
Step Operation
4 Do Auto
Set 100 %
value
5 Do Manual
Set 0 % value
6 Do Manual
Set 100 %
value
249
Press Result
When the motor stops, the display should stop
counting, then go to the next step.
Function Back to the configuration prompt Position
key Proportion.
Increment Until you see
key or
The increment relay is turned on to move the
Decrement
motor to 100 % position.
key
When the motor stops, the display should stop
counting, then, go to Step 7.
Function Back to the configuration prompt Position
key Proportion.
Increment Until you see
key or
Decrement
key
Function Enter into configuration prompt of
key
Increment Change the value.
key or
Decrement
key
Function Back to the configuration prompt Position
key Proportion.
Increment Until you see
key or function key to change the value.
Decrement
For manual calibration, the motor does not
key
move from its position prior to the start of
Position Proportional calibration.
Function Enter into configuration prompt of
key
Increment Change the value.
key or
Decrement
key
.
Span Value
.
Zero Value
, and press the
Span Value
.
Zero Value
.
Span Value