Honeywell UDC2800 Product Manual page 155

Chapter 4 - Configuration
Function
Prompt
A1S1 State
A1S1 Event
155
Selections or Range
of Setting
High Alarm
Low Alarm
Parameter Definition
prompt A1S1 Type to actuate. The value
depends on what the setpoint has been
configured to represent. No setpoint is
required for alarms configured for
Communications SHED.
ATTENTION: For SP Programming the
value is displayed as
the event applies. PxSy = Program x,
Segment y.
ATTENTION: In Easyset app, the SP
Programming value is displayed as
, for which the event applies.
Px.Sy00
Px.Sy00 = Program x. Segment y 00.
For example, Program2. Segment300
(2.300).
This prompt does not appear for "Alarm on
Manual" type alarm. For example: A1S1 Type
= Manual.
If Setpoint Programming is disabled or if the
Alarm Type is not configured for Event
On/Off:
Alarm 1 Setpoint 1 State —Select whether
you want the alarm type chosen in prompt
A1S1 Type to alarm High or Low.
High Alarm
Low Alarm
If Setpoint Programming is enabled and if
the Alarm Type is configured for Event
On/Off:
Alarm 1 Segment Event 1 —Select whether
you want the alarm type chosen in prompt
A1S1 Type to alarm the beginning or end of a
segment in setpoint Ramp/Soak
programming.
for which
PxSy