Table of Contents
Advertisement
15.3 Alignment bracket method
Pre‑fitted alignment brackets help protect and secure the readhead to the extrusion during
transit. These alignment brackets can also be used to set the readhead at the nominal installation
rideheight and remain in place during installation.
The alignment bracket can be loosened to allow position adjustment of the readhead (whilst
maintaining the correct rideheight) by loosening the M2.5 screw at the end of the bracket. The
alignment brackets must be fully removed following installation.
NOTE: This method cannot be used if an armoured cable is fitted, due to space restrictions.
1. Closed
2. Semi-open
3. Open
www.renishaw.com
31
Advertisement
Table of Contents
