Table of Contents
Advertisement
15.3.1 Installation using the alignment bracket method
1
Align the readhead mounting holes to the machine slideway
mounting holes.
Loosen the transit brackets enough to be able to move the readhead
up and down the extrusion. Align the readhead mounting holes to the
machine slideway mounting holes.
3
Remove the alignment brackets from the readhead and lift off the
extrusion.
32
FORTiS-N Functional Safety enclosed encoder system – original instructions
2
Secure the readhead to the machine slideway with the two supplied
serrated washers and M4 screws placed in the end cap mounting
holes. Tighten the screws to a torque of 2.5 Nm.
NOTE: Secure fastenings with Loctite 243.
4
IMPORTANT: The alignment brackets must be removed after
installation.
2.5 Nm
Advertisement
Table of Contents
