Table of Contents
Advertisement
15.4.2 Side setting shim procedure
1
Snap the shim to detach the two end section parts as shown above.
2
Place a section of the separated shim parts at either side of the readhead.
34
FORTiS-N Functional Safety enclosed encoder system – original instructions
3
Whilst maintaining light pressure on the readhead, secure the readhead with
2 × M4 screws, tighten the screws to 2.5 Nm to complete the installation.
NOTE: Secure fastenings with Loctite 243.
Remove the setting shim parts.
2.5 Nm
Advertisement
Table of Contents
