Table of Contents
Advertisement
Readhead mounting and alignment
Mounting brackets
The bracket must have a flat mounting surface and should provide adjustment to enable
conformance to the installation tolerances, allow adjustment to the rideheight of the readhead,
and be sufficiently stiff to prevent deflection or vibration of the readhead during operation.
NOTES:
•
The recommended screw type M2.5 × 0.45 and must comply with: ISO 4762/DIN 912 grade
8.8 minimum/ANSI B18.3.1M.
•
The use of a thread locking compound is recommended.
•
No washer is required under the screw head.
•
The minimum thread engagement is 5 mm (7.5 mm including counterbore).
•
The tightening torque should be between 0.25 Nm and 0.4 Nm.
•
The mounting hole clearance will contribute to mechanical safe position.
Original instructions
www.renishaw.com
45
Advertisement
Table of Contents
