Canon imageRUNNER ADVANCE System V3.13 Service Manual page 106

■ USB Device report print
To check the vendor IDs (idVendor) and the product IDs (idProduct) registered in this device by means of declaration in Manifest
file of MEAP applications, output the USB Device repot report print.
● Steps to output the USB Device report print
1. Execute the following service mode.
• COPIER > Function > MISC-P > USBH-PRT
2. When [OK] is shown on the status field, the status print is output. Check the contents of the print.
USB device information
T: Bus=01 Lev=02 Prnt=03 Port=01 Cnt=01 Dev#= 5 Spd=480 MxCh= 0
D: Ver=2.00 Cls=00(>ifc) Sub=00 Prot=00 MxPS=64 #Cfgs= 1
P: Vendor=066f ProdID=4210 Rev=10.02
S: Manifacturer=SigmaTel, Inc.
S: Product=STIr42xx
S: SerialNumber=0002F0F7261287A5
C:* #Ifs= 1 Cfg#= 1 Atr=80 MxPwr=100mA
I: If#= 0 Alt= 0 #EPs= 2 Cls=fe(app.) Sub=02 Prot=00 Driver=irda-usb
E: Ad=81(I) Atr=02(Bulk) MxPS=512 Ivl=0ms
E: Ad=01(O) Atr=02(Bulk) MxPS=512 Ivl=0ms
● USB device information Content
Display the information of the USB device, which the device recognized.
If not displayed, there may be some fault occurred.
Some of standard optional devices are not displayed on a report.
The details of each item are as follows.
T : Topology
Internal hierarchical structure, which a USB device is connected, is shown. The number of a connected bus, the hierarchical
structure and connection speed can be indicated.
D : Device
Information of USB devices is shown.
P : Product
Product information of USB devices is shown. Vendor ID and Product ID can be recognized here.
S : String
The character string embedded in a USB device is shown. A manufacture name and a product name can be recognized
here.
C : Configure
The configuration information of a USB device is shown. * mark is to know whether it is active.
I : Interface
The interface information of a USB device is shown. Interface class and the driver to handle can be recognized.
The value and the content of Driver are as follows.
Labeling
usbhid
usb-storage
hub
gpusb
********************************
*** USB Device report print ***
********************************
Example of output result
It is displayed when the USB system driver is assigned to the input device connected.
It is displayed when storage devices (USB flash drive etc.) are connected.
It is displayed when HUB is connected.
It is displayed when the USB driver only for MEAP application is assigned to the input device connected.
Content
101
6. MEAP Application Management