Canon imageRUNNER ADVANCE System V3.13 Service Manual page 77

■ Connection
The following IP address is automatically assigned for this machine at startup in download mode.
• IP address: 172.16.1.100
• Subnet mask: 255.255.255.0
When the PC with SST installed is connected to this machine, change the PC network address as follows:
• IP address: 172.16.1.160
• Subnet mask: 255.255.255.0
• Default gateway: arbitrary
CAUTION:
Ensure that the PC is disconnected from the network when you change the PC network settings. Alternatively use the cross
cable to connect to this machine.
1. Connect this machine and the PC with SST installed.
CAUTION:
Disconnect USB memory storage devices if connected.
This machine disables the communication to SST if any USB memory storage device is recognized. SST and the USB
memory storage device cannot be used concurrently.
2. Turn ON the main power switch of this machine.
3. Execute the following service mode to enter download mode.
• COPIER > Function > SYSTEM > DOWNLOAD
4. Check the IP address of the PC.
Type IPCONFIG and press the [Enter] key to see the network settings of the PC.
If any discrepancies from the description in the figure below are found, change the network settings of the PC.
■ Upgrading the System Software
● Assist mode
1. Connect this machine and the PC with SST installed.
2. Turn ON the machine power and execute the following service mode to enter download mode.
• COPIER > Function > SYSTEM > DOWNLOAD
3. Start SST, and click the [Start Assist Mode] button.
72
4. Firmware Management