Limitation; Automatic Updates For Options - Canon imageRUNNER ADVANCE System V3.13 Service Manual

7. When the system software is successfully registered to the USB memory storage device, click the [OK] button

Limitation

Do not turn OFF the power while downloading/writing the system software.
Doing so may cause a failure of machine startup.
If the machine becomes unable to start, start it up in download mode (safe mode)
NOTE:
With the previous models, the error code of E753-0001 occurs when downloading the system software for the option that is not
installed. With this machine, however, no error occurs even if downloading the system software for the option that is not installed.

Automatic Updates for Options

If the system software version of an added option or replaced PCB is not compatible with the system software of the host machine,
this function updates the option's system software to a compatible version stored in the host machine.
Option A
Data
Opt A Ver1.2
■ Requirements
When using this function, the following conditions must be met.
• The following service mode is configured.
• COPIER > OPTION > FNC-SW > VER-CHNG
• The following data is stored in the host machine.
• Target system software (including the options')
*1. by turning ON the power while pressing numeric keys 2 and 8
Machine
Data
System Software
Intallation
Data
PCB Ver 1.2
Upgrade
Data
Data
*1
, and download the software again.
OptA Ver2.0
Opt B Ver1.1
41
4. Firmware Management
PCB
Data
PCB Ver1.1
Option B
Data
Opt B Ver1.0