I- Connector Status - Circontrol Master-Satellite User Manual

I)
Connector status
The HMI screen shows different symbols, as you can see below:
24
Connector available, a Charging Session can be
started.
Connector charging, a Charging Session cannot
be started because it is already in use.
Connector disabled, a Charging Session cannot
be started because it is under maintenance or
because the Back office has decided to stop it.
Connector out of service, a Charging Session
cannot be started due to some error.
Tap on the 'Information' button in order to get
more information about it.
Connector reserved, a Charging Session can
only be started using the IdTag assigned to the
reservation.
The Charge Point is out of service because the
emergency button has been pressed. This fact
affects all the connectors at the same time.
Applies when simultaneous charge is not available.
In case, one connector is booked or already in use.
CIRCONTROL — Master-Satellite User Manual