Circontrol Master-Satellite User Manual page 38

4 — L O G G I N G I N
After you're complete with the setting up as described in the section above, you are
ready to start logging into your router and start configuring it.
This example shows how to connect through WiFi:
For cibersecurity reasons, modem's WiFi connection is
disabled by default.
In order to enable it, remember to adjust it in
Charge Point side, as explained in section 6.
4.1 Connect your ethernet cable in the LAN port and do all the settings being locally
connected (it can also be done from the WAN port when WAN port is configured as a
LAN).
4.2 At your service computer, look for access point named ChargePoint_xxxxxxxxxxxx
(where "x" means the serial number), and connect on it.
4.3 Open a web browser and type http://192.168.1.1, as shown in the front part of the
modem.
38
CIRCONTROL — Master-Satellite User Manual