Advertisement
2. Indicator instructions
Power ： After controller power on, power LED light
Run： Compressor operation，run LED light.
Alarm ： Early warning, the fault light flashes; fault shutdown, fault lights lit, clear fault, reset
off.
3. Display of status and operations
The display screen will be as follow when the units are powered on:
COMPRESSOR
After 5 seconds, the main page will show up as:
PRES: 0.60MPa
SYS STOP
Press shift button, the main page will show up as:
TEMP: 80℃
SYS STOP
Press "
Move down button
RUN PARA.
USER PARA.
FACTORY PARA.
MOD PARAMETER
4. Operating parameters
Press "
Move down button
press enter button to pop up submenu:
MOTOR(A) A-0100
B-0100 C-0100
Continuously press "
parameters as follows:
Fan current, Total run time, Total load time, This run time, This load time,
Oil filter time, O-a filter time, Air filter time, Lube time, Grease time, Belt time...etc.
SCREW
C01
C01
" to enter into Menu Selection Interface:
" or "
Move up button
Move down button
After power on,
Main page
Main page
Level 1 menu screen
Level 1 menu screen
" to move the black cursor to "RUN PARA.",
" you can see run parameters and run state
screen
show this page
Advertisement
